In the beta forum there was a f/w change log sticky. This was not avaialble to all and as the beta forum is now closed it isn't available to anybody.
Can ceton create a sticky here on TGB to have the f/w change logs posted please?
Firmware Change Logs
Forum rules
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
Ceton no longer participate in this forum. Official support may still be handled via the Ceton Ticket system.
-
Sammy2
- Posts: 1708
- Joined: Fri Aug 24, 2012 7:35 pm
- Location:
-
HTPC Specs:
I just realized something in the 1219 f/w that is of interest. It says, "Only output at modes supported by the TV".
My echo is going through my AVR via HDMI to my HDTV via HDMI. My HDTV supports all refresh rates and my AVR is set for i/p upscaling. So what does the echo read in this set up? The TV or the AVR? I do see the TV re-syncing even though it is going to 1920x1080 each time even for 720p and 1080i content because the AVR is upscaling it to 1080p. Is this occuring because in native mode the AVR is catching the signal from echo because it has been switched to differing resolutions?
My echo is going through my AVR via HDMI to my HDTV via HDMI. My HDTV supports all refresh rates and my AVR is set for i/p upscaling. So what does the echo read in this set up? The TV or the AVR? I do see the TV re-syncing even though it is going to 1920x1080 each time even for 720p and 1080i content because the AVR is upscaling it to 1080p. Is this occuring because in native mode the AVR is catching the signal from echo because it has been switched to differing resolutions?
-
Sammy2
- Posts: 1708
- Joined: Fri Aug 24, 2012 7:35 pm
- Location:
-
HTPC Specs:
Okay. Does it read through the AVR to the display for the EDID or does it go with what the AVR reports which is all resolutions usable by the echo through i/p upscaling?