I just did a clean install of Windows 8 on my HTPC. That said, everything is working very well with one exception. I changed the settings on my NIC to wake the computer with ANY network activity vs. defaulting to magic packet only. I did this so that the Companion app could wake my computer over LAN as well as WAN. With this change, the behavior is as expected, however each time I reboot my computer, the NIC settings return to default and will only wake for a magic packet. Since this is a fresh install vs. an upgrade I'm confident it's not something I installed or changed from my end...
Ay ideas?
NIC settings return to default after reboot
Forum rules
Ceton no longer participate in this forum. There is no official support mechanism for My Media Center.
Ceton no longer participate in this forum. There is no official support mechanism for My Media Center.
-
- Posts: 78
- Joined: Tue Apr 17, 2012 1:50 am
- Location:
- HTPC Specs:
-
- Posts: 201
- Joined: Fri Aug 31, 2012 10:48 am
- Location: Glendale, CA, USA
- HTPC Specs:
See if the network card chipset maker has drivers. If it is a realtek card or broadcom then download the correct driver directly from the manufacturer since the ones in windows update are not the best drivers for use.
Time is on my side.
-
- Posts: 78
- Joined: Tue Apr 17, 2012 1:50 am
- Location:
- HTPC Specs:
Thanks for the suggestion. I have a Realtek controller and interestingly enough there was an updated driver available on their site which I installed. That said however, after rebooting - the power management settings return to default as before.
I'm starting to wonder if this is simply a Windows 8 bug...
I'm starting to wonder if this is simply a Windows 8 bug...
-
- Posts: 1378
- Joined: Mon Aug 22, 2011 9:23 pm
- Location:
- HTPC Specs:
See if your PC has the same settings in the BIOS
Quality Assurance Manager, Ceton Corporation